Condensor Completed PDF Print E-mail
Written by Cliff Blackburn   
Sunday, 06 March 2011 08:23

I have been working on properly finishing off my still. The condenser is complete, there is a photo below.. I thought it came out quite well.  Finding a place that will sell cut to length 1" copper was a bit fun, but other than that it only took about an hour of soldering, and voila. If only copper was cheaper I would have built the entire column out of it. I am using sanitary stainless Tri-Clamp fittings so it is modular and easily cleanable.

The next thing to do is make a reflux coil which will attach where the RTD currently is... hopefully i'll take some photos..



Last Updated on Sunday, 06 March 2011 08:43

Add comment

Security code

Power Automation, Powered by Joomla!